Manual installation of the operating system on the public cloud

1.Log in to the raksmart backend and click on "Products & Services."

 

2.Enter the cloud product that you wish to operate on.

 

3.Before installation, ensure that the server is powered off, and then click on "Refresh Server Status."

 

4.After shutting down the server, click on "Settings" and select "Mount ISO Image." Confirm the selection and choose CDROM as the boot option. Confirm the settings and power on the server.

 

5.Once the server is powered on, click on the VNC window.

 

6.Follow the installation process prompts to manually install the operating system. You can configure the primary IP during the installation process or enter the system to configure it via VNC after installation.

 

7. After the system is installed, restart the system. Unmount the ISO image and adjust the boot option to "Hard Disk." Open the VNC window again to check the system status.

  • If the system does not boot into the operating system properly after installation, click on "Restart" to enter the system.
  • 0 Users Found This Useful
Was this answer helpful?

Related Articles

To enable Google two-factor authentication in the public cloud

To ensure the security of user Rak Cloud management panel, Rak Cloud service panel supports...

How to build an internal network in the public cloud

To create an internal network for cloud virtual machines, ensure that the machines are on the...

How to enter rescue mode in public cloud

1. If the server's operating system cannot boot normally but you need to back up data, you can...

Operating the Public Cloud Snapshot/Backup Function

1.In the backend, go to "Product Services" and click on "Public Cloud." Find the desired product...

How to log in to the public cloud control panel

1.Technical Support - Service Panel Password Reset - Select RAK Cloud Service Panel Password...